When we received the service call from a homeowner in Henderson, NV, their central cooling system wasn’t working as expected. The central AC unit was running, but airflow was weak, and the home just wouldn’t cool down properly. Our technicians at Fast Affordable Air geared up to check both the attic furnace system and the outdoor condenser unit to get to the root of the issue.
Step 1: Blower Compartment Inspection
Upon arriving in the attic, we opened up the furnace to inspect the blower motor and wiring. We looked for signs of overheating, burnt wires, or failed components. The blower wheel and shaft were clean, and the motor was intact — but the wiring needed attention. The control board was also tested for proper voltage and relay functions.
The blower motor is what pushes air through the ducts. If it’s not working right, even a cold air conditioner won’t cool the house well. We made sure the capacitor and transformer were also operating within range, both key parts in starting and regulating the motor’s performance.
Step 2: Electrical and Drain Line Setup
Next, we checked the electrical safety switches and PVC drain lines. These lines carry away the moisture your AC pulls from the air. Any clog or leak can cause major issues, especially in attic installations like this one. We ensured clean drainage and tested the float switch to make sure it would shut off the system in case of water backup.
Step 3: Outdoor Condenser Unit Testing
Outside the home, we opened up the condensing unit. Right away, we inspected the dual run capacitor — a cylindrical part with three terminals on top. This part helps both the fan motor and the compressor start and run properly. A weak or failed capacitor can cause your outdoor unit to buzz, hum, or fail to start altogether.
Using a multimeter, we tested the capacitor’s microfarads (μF) against the factory rating and found it to be out of spec. We replaced it with a new properly-rated capacitor. This small part can make a huge difference in system startup and efficiency.
Step 4: Refrigerant Pressure Check
We connected our Yellow Jacket manifold gauges to check refrigerant pressures. The readings showed normal superheat and subcooling levels, meaning no refrigerant leak was detected. Still, we did a quick visual inspection of all line connections and flare joints to be sure.
System Performance & Benefits
After replacing the capacitor and securing all control wiring, we ran the system through a full heating and cooling cycle. The airflow improved significantly with the blower working at proper speed. Temperatures at supply vents were within the expected range, and the customer noticed a big difference immediately.
- Energy Efficiency: A healthy capacitor keeps the compressor running smoothly, which uses less electricity.
- Comfort: Proper blower speed ensures even cooling throughout the house.
- Safety: Checked electrical boards, transformers, and float switches to prevent failures or attic leaks.
This repair was part of our ongoing commitment to keeping homes across Las Vegas, Henderson, and North Las Vegas cool and comfortable year-round. Whether it’s your central AC, heating and cooling combo, or just your air conditioner acting up, our team has you covered.