On this service call, our team at Fast Affordable Air worked on a central cooling system in Las Vegas. The homeowner reported that their AC wasn’t keeping the house cool, especially during the hotter hours of the day. Our job was to find out what was going wrong and fix it so their home could stay comfortable again.
Step 1: Hooking Up the Manifold Gauges
The first thing we did was connect our **Yellow Jacket manifold gauge set** to the outdoor condenser unit. These gauges help us read the pressure of the refrigerant, which is the chemical that moves through your system and makes the air cold. The red gauge is for the high side (pressure after the compressor), and the blue is for the low side (pressure before the compressor).
From the first photo, you’ll see the low-side gauge was reading around 110 PSI and the high side was near 210 PSI. These values were slightly lower than ideal for a system using **R-410A** refrigerant, which suggests that the unit might be undercharged or not operating efficiently.
Step 2: Checking Electrical Readings
Next, we used our **Fieldpiece SC260 multimeter** to check the electrical side of things. This clamp meter lets us measure how much current (amps) the AC is using while it’s running. It helps us make sure the compressor and fan motor are pulling the correct amount of power and not working too hard.
- In the second image, we recorded an amp draw of 0.17 amps—this is likely from the control circuit or a low load condition.
- Later, in another image, we got a reading of 7.13 amps from the compressor circuit, which is within normal operating range for a residential condenser.
We also tested the voltage to make sure the contactor, capacitor, and compressor were getting proper power.
Step 3: Inspecting the Electrical Panel
We opened up the control panel on the side of the condenser. Inside, we inspected the dual run capacitor, contactor, and wiring. This is a critical part of the AC system—if anything here is loose, burnt, or weak, the whole system could shut down or run inefficiently.
The capacitor, labeled “CBB65 SH 5+40uF ±5% 440V AC,” looked fine and passed our multimeter check. A weak capacitor can prevent the compressor or fan from starting, which could explain poor cooling performance. But in this case, the capacitor was working correctly.
Step 4: Measuring Air Temperature at the Vent
To finish up, we checked the supply air temperature using an infrared thermometer. You can see in the image that the temperature coming out of the vent was 67.0°F. While this isn’t bad, we generally like to see supply temperatures in the low 60s or even upper 50s if the system is fully charged and working efficiently. This gave us a final clue that the system might still be slightly low on refrigerant.
Summary of the Procedure
- Attached refrigerant gauges and found slightly low suction and head pressure
- Checked amp draw with Fieldpiece meter—compressor draw was within range
- Inspected capacitor and contactor for damage—no signs of failure
- Confirmed that all wiring was tight and secure
- Measured vent temperature at 67°F—cooling, but not at peak performance
Benefits for the Homeowner
By going through this thorough inspection, we helped the homeowner understand how their central air conditioner was performing. We didn’t just guess—we used tools to measure pressure, temperature, and electricity to find the real cause. This type of HVAC service helps:
- Improve indoor comfort by ensuring cool air is flowing
- Protect the system from damage caused by low refrigerant or electrical problems
- Save money on energy bills by making the unit run more efficiently
- Extend the life of the system through early maintenance and repair
For more information about our services, visit the AC repair page or browse all our HVAC services in Las Vegas.